Menu

Turndowns (Drip Forming or Drip Edging)

All roof cladding with a pitch of less than 8° must be provided with turn-downs after the roof is fixed, using special tools to ensure water flows directly into the gutter.

As the corrugated profile cannot be satisfactorily turned down, it is not permissible to terminate this profile below 8°. See Curved Roofs.

 

Profile Turndown

Providing a profile with a downturn will provide a positive drip edge and minimise the amount of sediment build-up at the gutter line.

Distortion should be avoided because it causes ponding and the collection of dirt, which in turn causes corrosion.

/cop/installation/turndowns
Revision Category: 
1 - Minor Errata
Revision Detail: 

This clause has been reviewed as part of a substantial revision of COP Clause 14. Installation.

Draft Clause: 
013_001_002_000_000_000_000_000_000